This kit fits 2013 - Current Subaru BRZ & Scion FR-S.
Ground Control FT86 Suspension Kit
Extensive design and testing has gone into bringing you one of the most complete and competent suspensions available for your FR-S/BRZ. From a mild street cruiser, to all out track car, this kit can be configured to handle whatever your needs may be.
This suspension package gives you the complete adjustability of our exclusive Top Mount Caster/Camber plates and custom fabricated strut housings. The combination of these parts not only allows you to lower the vehicles ride height beyond that of the competitors, but also maintain suspension bump travel when lowered. This isn’t a “one size fits all” suspension, each kit is built specifically for you and the intended use of your car.
Front Coilover Strut Assemblies:
Pre-assembled with camber plates and matching rear shocks. No spring compressor, cutting, welding or modification needed. Fabricated from 1026 DOM steel, this Ground Control strut is much stronger than the stock strut. Skip welded 0.250 flanges reduce flex while adding strength. Housings custom fabricated to provide over 1 more bump travel, reduced droop and Koni strut inserts specially valved by Koni of Holland for Ground Control or Koni race strut inserts are provided, depending on suitability with your spring rate. Exclusive GC coilover hardware with single-locking sleeve and and your choice of Eibach springs. We finish off with Ground Control bump stops and grade 8 fasteners.
Top Mount Camber/Caster Plates & Truss Bar:
More camber adjustment than stock. Ground Control designed bushings, engraved with calibrated degrees. Every component is anodized or plated, including fasteners. Adds extra travel to avoid excessive bottoming out, this is a very well engineered product and is exclusive to Ground Control. Camber and caster are quickly adjustable by sliding the mounts, without removing any components from the car. The priority of this design is to allow repeatable alignment changes for fine tuning. Integrated truss bar adds to rigidity and minimizes front chassis flex.
Rear Coilover Assemblies:
We start with a Ground Control designed rear upper shock mount. Machined from Billet aluminum and including urethane bushings. We then add a Koni Race valved shock matched with custom Ground Control mounting hardware, grade 8 fasteners and GC bumpstop. We utilize a Koni single adjustible mono tube rear shock, adjustable for rebound damping. This shock is available in our standard default damping for standard to aggressively driven cars, or heavier damping for track cars with higher spring rates. The Koni shock features the exclusive GC coilover hardware with single-locking sleeve and and your choice of Eibach springs.
* Suspension is shipped assembled and preadjusted*